Save EEPROM

From OpenMBD
< HANcoder‎ | STM32‎ | Blocks
Jump to: navigation, search
Supported Targets: Olimexino, E407, P405

General information about Save EEPROM

The STM32 controller does not have dedicated EEPROM on-chip. All EEPROM write, read and erase operations are therefore performed in a RAM buffer. To make sure RAM buffer contents are still valid after a power-off, its contents needs to be save in flash EEPROM, which is achieved with this block. This is typically called during the software shutdown sequence, right before power off.

Block

SaveEEPROMBlock.png

Mask

SaveEEPROMMask.png

Block inputs (inports)

Trigger input: When this signal changes from 0 to 1 the block is executed and the EEPROM is saved.

Examples

Using EEPROM

See Also

Read from EEPROM | Write to EEPROM | Erase EEPROM