UDS Verify Key Event
From OpenMBD
Supported Targets: Olimexino, E407, P405
General information about UDS Verify Key Event
A 'UDS Verify Key Event' block is needed when the parameter 'UDS seed/key required' is set to TRUE (checked) in the 'UDS Init' block.
This block has a function call output that gets triggered during a seed/key sequence, when the UDS module received a 32-bit key from the tester that needs to be verified. The connected subsystem should contain a 'UDS Set Key Verfied' block to inform the UDS module if the received key was correct.
Output
Event The output port allows the connection of a function call subsystem. It could also be terminated when not in use.
Block
Mask
