UDS Verify Key Event
From OpenMBD
Supported Targets: Olimexino, E407, P405
Contents
General information about UDS Verify Key Event
This block has a function call output that gets triggered during a seed/key sequence, when the UDS module received a 32-bit key from the tester that needs to be verified. The connected subsystem should contain a 'UDS Set Key Verified' block to inform the UDS module if the received key was correct. A 'UDS Verify Key Event' block is needed when the parameter 'UDS seed/key required' is set to TRUE (checked) in the 'UDS Init' block.
Block
Mask
Outputs (outports)
The output port allows the connection of a function call subsystem. It can also be terminated when not in use.
See Also
UDS Get Key | UDS Get Seed | UDS Get Seed Event | UDS Init | UDS Set Key Verified | UDS Set Seed
