General information about UART Init
This block initialized a UART channel.
Data (byte) to send to the slave device.[uint8] Note: To send multiple bytes use mutliple Master Transfer blocks
(optional) If this output has a value of 0, the UART driver could not be initialized. This happens if no space could be allocated on the heap for the transmit and/or receive buffer. Use the 'Get free heap' block to verify that enough space is available on the heap. The used datatype is boolean.
|Channel||Select channelfor UART communication|
|Baudrate||Select the baudrate to be used for the communication|
|Databits||Select the number of databits per message. (8 or 9)|
|Parity||Select whether to use the parity bit and if it should be odd or even.|
|Stopbits||Select the number of stopbits.|
|TransmitBufferSize||Enter the size (in bytes) of the buffer for transmitting. The buffer space is reserved in HEAP.|
|ReceiveBufferSize||Enter the size (in bytes) of the buffer for receiving. The buffer space is reserved in HEAP.|
|Use status output||Enable the status output to check if the initialization has been successful.|