View source for HiL Connection Schematic
You do not have permission to edit this page, for the following reason:
You can view and copy the source of this page.
Return to HiL Connection Schematic.
You do not have permission to edit this page, for the following reason:
The action you have requested is limited to users in one of the groups: Administrators, Bureaucrats.
You can view and copy the source of this page.
Return to HiL Connection Schematic.
This page depicts the necessary connections for the HiL Autodocking Demo. The connections are done according to the schematic below.
The Lely GCB is to be connected as seen in the picture below.
In this case, the ETH1 Port is used for Ethernet connection with the Switch, and the PWR port connected to the Power Source.
The switch is connected to the Power Source and, through Ethernet, to the computer, the I/O Module (STM32), and Lely GCB.
Note: The order of connection in ethernet ports is not important.
The computer is connected, through the ethernet port, to the switch to enable control of the Lely GCB. Further, the computer connects to the I/O Module (STM32) with a USB connection. This USB connection is to read the signals from the I/O Module using HANtune.
The I/O Module (STM32) is connected to the Computer, Switch, Power Source, and CAN Connector as seen below.
The CAN connections are: