Difference between revisions of "HANcoder/STM32/Blocks/XCP On CAN Config"
From OpenMBD
m (Jasonvankolfschoten moved page HANcoder/XCP On CAN Config to HANcoder/STM32/Blocks/XCP On CAN Config without leaving a redirect) |
|||
Line 32: | Line 32: | ||
{{HANcoder/BlockFooter| | {{HANcoder/BlockFooter| | ||
− | |SeeAlso = [[HANcoder/CAN_Config| CAN config ]] | + | |SeeAlso = [[HANcoder/STM32/Blocks/CAN_Config| CAN config ]] |
}} | }} |
Revision as of 10:24, 5 May 2017
Supported Targets: Olimexino, E407, P405
Contents
General information about XCP On CAN Config
A 'XCP Config' block instructs the code generator to include the XCP over CAN protocol. The XCP protocol is used to communicate with HANtune.
Block
Mask
Block parameters
Parameter | Description |
---|---|
CAN channel | CAN channel to use for XCP communication with HANtune. |
CRO Identifier | The identifier of the messages that come from HANtune. |
DTO Identifier | The identifier of the messages from the microcontroller to HANtune. |