Difference between revisions of "HANcoder/STM32/Blocks/Save EEPROM"
From OpenMBD
m (Jasonvankolfschoten moved page HANcoder/Save EEPROM to HANcoder/STM32/Blocks/Save EEPROM without leaving a redirect) |
|||
| Line 23: | Line 23: | ||
{{HANcoder/BlockFooter| | {{HANcoder/BlockFooter| | ||
| − | |SeeAlso = [[HANcoder/Read_from_EEPROM|Read from EEPROM]] {{!}} [[HANcoder/Write_to_EEPROM|Write to EEPROM]] {{!}} [[HANcoder/Erase_EEPROM|Erase EEPROM]] | + | |SeeAlso = [[HANcoder/STM32/Blocks/Read_from_EEPROM|Read from EEPROM]] {{!}} [[HANcoder/STM32/Blocks/Write_to_EEPROM|Write to EEPROM]] {{!}} [[HANcoder/STM32/Blocks/Erase_EEPROM|Erase EEPROM]] |
}} | }} | ||
Latest revision as of 10:21, 5 May 2017
Supported Targets: Olimexino, E407, P405
Contents
General information about Save EEPROM
The STM32 controller does not have dedicated EEPROM on-chip. All EEPROM write, read and erase operations are therefore performed in a RAM buffer. To make sure RAM buffer contents are still valid after a power-off, its contents needs to be save in flash EEPROM, which is achieved with this block. This is typically called during the software shutdown sequence, right before power off.
Block
Mask
Block inputs (inports)
Trigger input: When this signal changes from 0 to 1 the block is executed and the EEPROM is saved.
