Difference between revisions of "HANcoder/STM32/Blocks/XCP On USB Config"
Line 14: | Line 14: | ||
{{HANcoder/BlockFooter| | {{HANcoder/BlockFooter| | ||
− | |SeeAlso = [[HANcoder/ | + | |SeeAlso = [[HANcoder/XCP_On_CAN_Config| XCP on CAN config]] |
}} | }} |
Revision as of 13:13, 27 April 2017
Supported Targets: Olimexino, E407, P405
General information about XCP On USB Config
A 'XCP Config' block instructs the code generator to include the XCP over USB protocol, the XCP protocol is used for communication with HANtune. A USB communication stack is automatically included that makes the controller show up as a virtual COM port on the PC. Use the Windows Device Manager to determine the COM port number. Configure 115200 bits/sec as the communication speed on the PC side.